Guangdong Zhengbao Technology Co., Ltd. XLR and 6.35 socket development doubts
1. 6.35 socket questions: 1. The total depth of the product30.46mm,6.3530.46 \mathrm{~mm}, 6.35 Plug lengths of 30 - 31.5 mm are not guaranteed30.5-31.5mm30.5-31.5 \mathrm{~mm} The length plug is fully inserted in place; After the installation of your product, is there a limit plug structure device at the head to increase the depth of the product, and can you provide the height of the device? (As shown in the size on the right side of the picture) 2. The highest point of the R-end shrapnel of the product is far from the end face of the product22.53mm,6.3522.53 \mathrm{~mm}, 6.35 The recess of the R end of the plug is 25.25 mm away from the end face of the plug, and the highest point of the T-end shrapnel cannot be guaranteed to fall into the recess of the R end of the plug, and the plug extraction force cannot be guaranteed; After the installation of your product, is there a limit plug structure device on the head to ensure that the highest part of the R-end shrapnel falls into the recess of the R-end of the plug, can you provide the height of the device? (As shown in the size on the left side of the picture on the right) 3. The bottom cover of the product has no buckle device, and it is tightly fixed by the terminal, does it ensure that the product does not move before installation to meet your company's requirements? (As shown on the bottom of the picture on the right) 1. Pink filling is the outline of the base
2. The blue fill is the R-end terminal profile 3, and the red is the 6.35 plug profile 4. Yellow is the outline of the bottom cover of the product
Guangdong Zhengbao Technology Co., Ltd. XLR and 6.35 socket development doubts
1. 6.35 socket questions:
4. The forming process of the elastic part of the R end is a tear bending process, and the tear edge and the substrate are in a transitional (no gap) fit state. After the plug is inserted, the elastic part of the R terminal will be bent back to the unbent plane state, and the substrate will be completely closed, when the matrix or elastic part is burred or deformed, the elastic part will be stuck in the base body and cannot be ejected, resulting in the risk of poor contact. (pictured on the right)
1. Pink filling is the outline of the base 2. The blue fill is the outline of the terminal at the R end
3. Red is the 6.35 plug profile
Guangdong Zhengbao Technology Co., Ltd
XLR and 6.35 socket development doubts
2. XLR socket questions:
1. The depth of the groove in the middle of the product is super good and half of the product, and the groove opening has the risk of indentation after injection molding. Whether the parts will be installed in the groove of your company, if so, please inform the dimensions and matching tolerances of the parts, so that our company can prevent them before development;
2. Product contact jack hole distance, IEC standard: 8.12**3.96mm8.12 * 3.96 \mathrm{~mm} , product drawing: 8.10**4.05mm8.10 * 4.05 \mathrm{~mm} , whether your company uses a special plug, please confirm? (as shown in the picture below right).
